• For laboratory work using circulation or flow-through processing.

• Simple, compact and sturdy modular design

• Sterilizable, autoclave-compatible

• Table-top or stand-supported device, low space requirement

• Easy disassembly

• Large delivery capacity of 4.4 to 11.6 l/min with open outlet (the mounting of a valve reduces the delivery capacity)

• For air-free, sterile, and in-line suspension, emulsifying and desagglomeration

• For vacuum or pressurized operation (up to 6 bar)

• If the DK 25.11 is used, air induction is also prevented in batch mode

• Not self-priming

• A pump can also be connected between the intake nozzle and vessel. As a result, viscous fluids can also be processed.

(Image not Shown)

S 25 KV – 25 G – IL Dispersing Element

The variety of media to be processed also requires a variety of rotor-stator configurations and seals. In many cases it is necessary to use subsequently two dispersing elements, for pre-crushing and fine crushing. The plug-in connectors facilitate the exchange of the dispersing elements.

DK 25/11 Flow Chamber

For S 25 KV - 25 ... - IL dispersing elements. Allows inline operation mode, see UTL 25 basic.
Batch operation:
DK 25.11 is mounted around the dispersing element. The DK 25.11 must be at a lower elevation than the surface of the liquid during operation. With this operating mode, no air is drawn in as a result of turbulence in the vessel.

AD 25

Mounting support for DK 25.11

DK 50.11 Flow Chamber

For S 50 KV - G 45 ... - IL dispersing elements. Allows operation in inline mode, see UTL 50 basic.
If used in batch mode: DK 50.11 is mounted around the dispersing element. The DK 50.11 must be at a lower elevation than the surface of the liquid during operation. With this operating mode, no air is drawn in as a result of turbulence in the vessel.

(Image not Shown)

DZM Control Revolution Counter

Connection of an opto-electronic sensor enables measurement of the speed of rotating shafts from 0 - 50,000 rpm.
The signals received are displayed on the monitor. This enables all IKA overhead stirrers and dispersing instruments to be retrofitted with a speed display, thereby allowing reproducible work. An RS 232 interface allows the values to be recorded digital on a PC. An analog output signal for a recorder is also available. The monitor can be used as a table-top device or mounted on a stand rod.